|
Emerald-MM-8P offers 8 multi-protocol serial ports on a single PC/104 module with complete software configurability. Each port can be individually selected for RS-232, RS-422, or RS-485 under software control. Both local-echo and non-local-echo modes are supported for RS-485. I/O addresses and interrupt levels are also programmable, with interrupt sharing available for any number of ports. Each port may further be enabled or disabled in software. All configuration data is stored in an on-board EEPROM that is loaded automatically on power-up.
For applications where fixed addresses are desired, four groups of preset addresses are available with jumper settings that override the programmed settings. Line termination for RS-422/485 modes is also jumper-selectable. Emerald-MM-8P offers 8 convenient digital I/O lines. The direction of each line is independently programmable.
Key Features
- 8 serial ports, upto 460.8kbps
- RS-232/RS-422/RS-485
- Software selectable I/O,IRQs
- Dual 40-pin I/O headers
- Flexible address & IRQ selection
- IRQ status register for WinNT
- Emerald-8M replacement
- +5V only power supply
- -40 to +85°C operation
- Proper hardware serial port with - works with any O/S!
- ROHS compliant
This board has a dual 40 pin connector - DSC serial cable is C-DB9M-4 .
This board is just one of a range of high quality serial, analog and digital I/O boards from Diamond Systems - refer to our main website for other boards in their range.
|
